The cause of the failure of the submersible pump not pumping water

F.OR.TEC.ForumIl corso e-learning F.OR.TEC.The cause of the failure of the submersible pump not pumping water

This topic has 1 voice, contains 0 replies, and was last updated by  seventrust 65 giorni ago.

Viewing 1 post
Author Articoli
Author Articoli
14 maggio 2019 at 03:39 #132064

seventrust
Post count: 15016

     The submersible pump’s seal is too tight for the packing, the cooling water cannot enter the packing, or the shaft surface is damaged. Some measures can be taken, such as properly relaxing the packing and cleaning the sealing tube. Packing wear must be replaced. Pre-installed in the place where the oil is immersed, and then turn into the incision to be staggered to reduce water leakage.

1. Submersible pump vibrates

     It may be that the electric rotor is unbalanced, or the coupling is not well combined, the bearing is worn and bent, or the rotating parts are loose and broken, or the pipe bracket is not firm, etc., which can be individually adjusted, repaired, reinforced, and replaced.
read more:

[url=https://www.vacuumpumpfactory.com/vacuum-pumps/2189.html]edm machine w-1 tungsten wire for electric vacuum parts[/url]
[url=https://www.vacpumpmanufacturer.com/pump-fabricate/2583.html]China Function Of Vacuum Pump[/url]
[url=https://www.vacuumequipmentsupply.com/furnace-equipment/1271.html]vacuum hot press furnace sintering furnace hot press sintering machine[/url]
[url=https://www.vacuumequipmentsupply.com/vacuum-furnace/1923.html]finely processed pump vacuum pump[/url]

Viewing 1 post

You must be logged in to reply to this topic.